Skip to content
HoldField
← Demo console

For cable harness and interconnect teams

Harness routing, connector, and termination inspection evidence.

Controlled inspection for harness routing, connector seating, and termination — with coverage proof and evidence for build verification.

Run the live inspection cycleBuild a station fit report

Cable Harness & Interconnect inspection-to-evidence story

  1. Step 1: the Cable Harness & Interconnect inspection cell is running.
  2. Step 2: inspection identifies connector/termination fault before test.
  3. Step 3: sealed evidence: routing · seating · coverage proof.
  4. Step 4: a NCR draft is prepared — ncr draft + disposition review prepared.
  5. Step 5: human approval is required before any decision; nothing is released or closed automatically.
  6. Step 6: build-verification evidence ready to export.

From factory signal to audit-ready record

Human-controlled
System preparedHuman approval requiredNo automatic release

Where teams usually start

  1. Connector seating verification
  2. Harness routing / completeness
  3. Termination / crimp check

Example part & rule

Example part Populated PCB

Reject a solder bridge above 0.25 mm in a critical region.

measured 0.4 mmlimit 0.25 mm
REJECT
solder bridgemissing componenttombstonemarking error

Discovery questions for the conversation

Which inspection station should we map first?

The goal is to identify one station where this could matter — then validate with your approved parts and criteria.

Build the deployment plan

This is an example workflow for cable harness & interconnectteams — a hypothesis, not a claim about any specific company's process.

Demo scenes are illustrative and use deterministic product scenarios. Regulated decisions remain human-controlled.